A pole saw allows you to cut high branches without reaching the trees using a ladder. Two types are available, such as the manual pole saw and powered pole saw. A pole saw provides the easiest way to get overhead tree limbs cut.
The use of hand pruner or chainsaws to cut high branches on trees is quite common among DIYers, but a ladder is required. Moreover, you have to reposition the ladder over and over again. But, to cut tree limbs with pole saw, you need not care about these additional things.
How To Cut Tree Limbs With Pole Saw – A Step by Step Guide
Things You Will Need
- A pole saw
- Hard hat
- Work gloves
- Protective eye goggles
- Work boots
Pole Saw Safety Tips
While operating a pole saw, you must take protective measures to keep yourself safe. As you are cutting overhead tree branches, there is a risk of falling cut branches on you. Do not forget to wear a long-legged pant and long-sleeved shirt. Using Hard hat or helmet and work boots is recommended as you want to protect yourself from injuries. Gloves save your finger from vibration, and eye goggles from the dust and flying wood chips.
5 Steps to Cut Tree Limbs with Pole Saw
Step #1: Check for Safety
This is the first advice, never start to cut high branches without your safety kits. You must equip all your safety gears before making a single attempt to cut branches. Anything falling from above may cause bodily injuries. So, you should remain very wary while operating pole saws.
Step #2: Clear the Area
Keep people away from the work area. Walking or standing within the operative range might cause severe injuries to the visitors and passersby. Moreover, you need to be careful about reentrance of people while cutting tree limbs with pole saw.
Step #3: Select the Branch
Mark the branch you need to cut and position yourself. Using both hands, extend the pole up to the branch and adjust the pole height at your chest level. Select a convenient position to stand off to the selected branch. Remember, you must not stand below the branch which you want to cut.
Step #4: Saw Positioning
Firstly, hold the pole to make a 45° angle to the branch and then make slow strokes to get a “V” cut. Try to reverse your direction and maintain a single angle all the time. Your saw may slip sideways on these slows strokes. Just stop cutting, reposition again and start cutting again with full energy.
Step #5: Finish Your Cut
Gradually increase pressure on your strokes and try to secure your saw in the groove. Like other pruning saws, continue cut through the branch applying faster strokes. You must keep eyes on both the branch and surrounding areas in order to get the job done safely. When the cutting limb is completed, clear the fallen branch before starting another cut.
Modern technology has made it easy for homeowners to take care of trees, especially when it comes to trimming and pruning. The job becomes easier and innovating with an electric and adjustable pole saw.
Whether you are a beginner or DYIer, you can operate a pole saw effectively with a little physical labor. Our last piece of advice for beginners is that they should avoid an attempt to cut branches thicker than 10 inches.
Leave a Comment